Pioneer CDJ-2000NXS2 Service Manual page 44

1
Step command
A
A series of operations for the set-up will be carried out step by step.
If the CUE/LOOP CALL NEXT (d) button is pressed, the procedure will step up (even if the PREV (c) button is pressed,
the step down will not occur.) Operation and display of each step are as follows.
Step
STEP0 : Servo All Off
STEP1 : Laser diode on
STEP2 : Disc presence judgment
STEP3 : Spindle on (2000 rpm)
STEP4 : Disc sense
STEP5 : Focus serve on
STEP6 : Tracking servo on
B
STEP7 : Focus position coarse adjustment
STEP8 : Focus gain adjustment
STEP9 : Tracking gain adjustment
STEP10 : Address lead start
CUE/LOOP CALL NEXT (d) button : step up
Mode Change (The end of the test movement mode)
If the MASTER TEMPO button is pressed in the "test operation mode", MASTER TEMPO LED will light off and servo will stop.
The mode will be switched to the "player operation mode" as mentioned above. [PLAYER MODE] will be displayed in the drive
condition indication section.
C
D
E
F
44
1
2
Action Indication Part
ALL OFF
LD ON
DISC SEARCH
SPINDLE ON
DISC SENSE
FOCUS ON
TRACKING ON
FOCUS POSITION
FOCUS GAIN
TRACKING GAIN
ADDRESS READ
CDJ-2000NXS2
2
3
3
4
4