ABB D1M 15 User Manual page 34

34 D1M 15 MULTIMETER USER MANUAL
PHASE
When a variable is selected, a specific phase of the variable needs to be selected.
CFG>ALM>PHS
Phase
L1
L2
L3
TOT
Different variables contain different phases, so the phase selection depends on the variable selected.
TYPE
TYPE includes MAX (cross-up event) and MIN (cross-down event).
CFG>ALM>TYP
SETPOINT
SETPOINT includes numerical value and magnitude. Different variables correspond to different
thresholds, magnitudes, and units, and you need to select variables before setting SETPOINT.
Variable
Active Power
Active Power Total
Reactive Power
Reactive Power Total
Apparent Power
Apparent Power Total
Power Factor
Current
Phase Voltage
Line Voltage
Frequency
Notes: The upper limit of each setpoint is calculated based on the maximum values of CT and VT primary
and increase redundancy by 20% except for some particular variables.
Description
Phase 1
Phase 2
Phase 3
Total phase (when PT/QT/ST/PFT is selected variable)
Value range
0~9999MW
0~9999MW
0~9999MVar
0~9999MVar
0~9999MVA
0~9999MVA
0.000~0.999
0.000~(50*120%)kA
0.000~(750*120%)kV
0.000~(750*√3*120%)kV
0~70Hz