Frigidaire PCFI3080AF Use & Care Manual page 21

Suggested induction cooking zone settings
Start most cooking operations on a higher setting
and then turn to a lower setting to finish cooking.
The suggested settings found in Table 1 below are
based on cooking with medium-weight stainless
steel pans with lids. Settings may vary when using
other types of pans.
electrolux induction recommendations
temp
range
Low
Medium
Low
Medium
Medium
High
High
Power
Boil
table 1: Suggested induction cooking zone set-
tings
note:
• The size and type of the cookware used and
the amount and type of food being cooked will
influence the setting needed for best cooking
results.
• The cooktop will remain on Power Boil for up
to 10 minutes. After 10 minutes, the cooking
zone will automatically change to the high (9)
setting
• The Hot Surface indicator (H) will show in the
setting indicator when heat is detected in a
cook zone that has been turned off. The indica-
tor will remain on until the heated surface area
has cooled sufficiently.
Pow- Description
er
level
1 Keep foods warm
2-4 Continue cooking,
poach, stew
5-6 Maintain a slow boil,
thicken sauces and
gravies, steaming,
cooking
7-8 Continue a rapid
boil, fry, or deep fry
9 Start most foods,
maintain water at a
boil, pan cooking,
searing
P Start heating pans
that contain large
amounts of food
or to bring pots of
water to boil
Setting Surface controlS
Bridge function
The Bridge function allows you to use an
extra-long piece of cookware such as a
griddle on the left side of your cooktop.
If one of the left cook zones is active and
cookware is detected in both of the left
zones, the bridge function becomes available.
1. Turn the cooktop on by pressing the Power key.
2. Place correctly sized cookware on the front
left and back left cooking zones. The zone will
become active.
3. Press the on-off key for the front left cooking
zone. The Power Level Indicator for the cooking
zone will show "0".
4. Touch the Bridge control to activate the bridge
function. The LED indicators next to the control
will turn red, and the cook zone setting for both
of the bridged zones will become linked
5. Press 4 on the power level selection bar. The
power level for both zones will be set to 4.
At any time, you can change the setting for the
bridged cook zones by pressing the number of the
new setting on the active control.
To deactivate the bridge function, press the Bridge
control or deactivate one of the bridged cooking
zones by pressing its on-off key.
21