Table of Contents
Advertisement
54
Before You Call
Self-Clean Problems
Problem
Self clean does not work.
Oven racks discolored or
do not slide easily.
Soil not completely re-
moved after self clean.
The oven control display
shows "SPr" and self-clean
is not working.
other Problems
Problem
Appliance is not level.
Cannot move appliance
easily. Appliance must be
accessible for service.
Oven light does not work.
Cause / Solution
Oven control not set properly. See "Setting Self Clean" on page 41.
Oven racks left in oven cavity during self clean. Remove oven racks from
oven cavity before starting a self-clean cycle. Clean by using a mild abrasive
cleaner following manufacturer's instructions. Rinse with clean water, dry,
and replace in oven.
Self clean was interrupted. Review instructions on "Self Cleaning" on page
40.
Excessive spills on oven bottom. Remove excessive spills before starting self
clean.
Failure to clean soil from the oven frame, the door liner outside the oven
door gasket, and the small area at the front center of the oven bottom.
These areas are not in the self-cleaning area, but get hot enough to burn on
residue. Clean these areas before starting the self-cleaning cycle. Burned-on
residue can be cleaned with a stiff nylon brush and water or a nylon scrub-
ber. Be careful not to damage the oven gasket.
The cooktop should not be used during a self-clean cycle. On some mod-
els, turning on any cooktop surface element or burner will cause the clean
cycle to cancel. If the clean cycle is canceled, the oven control display will
show "SPr" for 5 seconds. The oven door will remain locked until the oven
has cooled down below cleaning temperature. If the oven is below cleaning
temperature, the user can start another clean cycle immediately. If the oven
is in cleaning temperature range, another self-clean cycle can be set once
the door unlocks (up to 4 hours).
Cause / Solution
Be sure the floor is level, strong, and stable enough to adequately support
the range.
If the floor is sagging or sloping, contact a carpenter to correct the situa-
tion.
Poor installation. Place the oven rack in the center of the oven. Place a level
on the oven rack. Adjust the leveling legs at the base of the appliance until
the rack is level.
Kitchen cabinet alignment may make range appear not level. Be sure cabi-
nets are square and have sufficient room for appliance clearance.
Cabinets not square or are built in too tightly. Contact the builder or install-
er to make the appliance accessible.
Carpet interferes with appliance. Provide sufficient space so the appliance
can be lifted over carpet. Installation over carpet is not advised. See the
installation instructions for guidelines specific to your appliance.
Be sure the oven light is secure in the socket. See "Replacing the Oven
Light" on page 48.
Advertisement
Table of Contents
