Special Settings - Fujitsu CT114 Instruction Manual

Cleave Menu

Special Settings

This parameter is displayed when the cleave mode is changed from "Normal" to "Special".
Unlike the "Normal" mode, the special mode can cleave the fiber, leaving fewer scores
from the cleaving blade.
Parameter
Special Settings
Re-Tension Step
Re-Tension Limit
Wait After Oscillation
Wait After Re-Tension Sets the wait time between tension increments in special mode.
Cleaver operation modes
The figure below shows the difference between cleaver operation in "Normal" mode or
"Special" mode.
Blade oscillation starts
Normal Mode
Blade oscillation starts in Special mode
A Re-Tension Step [gf]
B Re-Tension Limit [gf]
C Wait After Oscillation [sec.]
D Wait After Re-Tension [sec.]
E Blade scores the fiber and the blade oscillation finishes in "Special Mode".
F The cleaver scored the fiber sufficiently, the fiber will break and the cleaving
operation is finished in "Normal" mode.
Description
Sets the tension increment value during special mode operation.
Sets the cleave tension limit value during the special mode.
Indicates the increment from the [Cleave Tension].
ex) When [Cleave Tension is "500gf", apply the tension up to"750gf"
Sets the wait time after the blade oscillations until the cleaver starts
increasing the tension in special mode.
F
E
A
C
CT114_Rev
Special Mode
A
D
D
2
B
A
Time [sec.]
50