Table of Contents
Advertisement
Maintenance Menu
Fiber Holder Adapter Installation
To attach the Fiber Holder Adapter, use the following process:
"Fiber Name" icon is a shortcut to the menu that holds the "Fiber Holder
Procedure
1. Press the DOWN key in the [Ready] or [Reset] state.
2. Select the [Fiber Holder Adapter Installation] function in [Maintenance Menu].
Press the SET key.
3. Unit will reset, then the left clamp will retract.
4. Remove the scale base and the connector cover.
5. Install the Fiber Holder Adapter while the cleaver is powered off.
6. Turn the power ON. The left clamp will move forward and stop at the back of
the fiber holder adapter.
Be careful not to drop the screws or the Fiber Holder Adapter inside the device.
When removing the Fiber Holder Adapter, reverse the above process.
Adapter installation" function.
CT114_Rev
2
69
Advertisement
Table of Contents
