Canon Arizona 6100 XTHF Mark II Series User Manual page 101

NOTE
For printing in "Express" mode the UV lamp power level is fixed at the highest possible level by
the printer .
Sound Output
Sound output for the high flow vacuum system is dependent on the following operating
parameters:
• Media type (porous, nonporous)
• Number of vacuum pumps operating
• Level of venting
The following table indicates typical sound outputs from the printer under different operating
conditions:
Media
Porous
(corrugated card-
board)
Non-porous
(flat media)
Non-porous
(warped media)
Open (non-masked) vacuum holes will greatly increase sound output. All exposed vacuum holes
should be masked when vacuum is applied to the table.
Pumps Active
(Recommended)
3
1
3
Printing on the High Flow Vacuum Table
Vents Active
25%-100%
0
0
Chapter 5 - Operating the Vacuum System
Sound Output
(dBA)
73-78
64-68
66-70
101