Canon Arizona 6100 XTHF Mark II Series User Manual page 138

Print White Ink Jobs
[17] Hold for Operator
5. Define or verify the layer definitions prior to sending the job to the printer. See section
the Layers on page 138
6. Submit the print job (i.e., process/rip the job).
7. Send the job to the printer and then print it.
Print a Single Layer Print Job with White Ink
For print jobs that do not use Quality-Layered mode:
NOTE
When you print white ink with print modes other than Quality-Layered, it is not recommended to
print white ink in the same area of an image as CMYK inks. The white ink does not mix well with
the other ink colors.
1. Create spot data in a design application. See
page 131
2. Open the job in ONYX workflow software using any print mode other than Quality-Layered
with an ONYX media profile that supports printing of white spot ink . (See
Thrive for White Ink on page
3. Submit the print job (i.e., process/rip the job).
4. Send the job to the printer and then print it.
Define the Layers
The Quality-Layered print mode can be used to print three, two, or one layer of image data or
printer generated flood data. All layers are independent of each other.
Quality-Layered layers are defined in ONYX media - mode options, but may be optionally
overridden within a Quick Set - Media Options, and optionally overridden on a per job basis by
138 Chapter 7 - How to Manage a White Ink Workflow
for more information.
NOTE
Not required if the layer definitions were correctly specified in the ONYX profile or
Quick Set.
Create Spot Data in Photoshop on page
or
117)
Create Spot Data in Adobe Illustrator on
128.
Define
Configure ONYX