Residual Risk Area
WARNING
High Risk Crush and Thermal
Hazard
High Risk Crush Hazards and Thermal Haz-
ards are created by allowing operator di-
rect access to the carriage when the center
maintenance panel is lowered. Motion
Motors are disconnected via hardware
when this panel is lowered.
WARNING
Crush Hazard
Medium risk crushing hazards are created
by alignment pins and the gantry rails.
WARNING
Shear Hazard at Porous Media
Option Vacuum Table
The Arizona 61x0 XTHF Mark II has an
overlay that is 25mm/1 inch in height. This
reduces the working range of the Z Axis
from 50mm/2 inches, and creates a couple
of additional Shear Hazards. The area is
easily accessible and accessed during nor-
mal use by operator. Although the motion
and step size during printing is expected
to be small during normal printing, a User
could be caught by surprise, especially
during a higher velocity/freewheeling gan-
try movement.
Hazard
Chapter 2 - Safety Information
Safety Awareness
4
51