Printer Interface Software - Canon Arizona 6100 XTHF Mark II Series User Manual

Printer Interface Software

Printer Interface Software
Introduction
The printer software user interface is displayed on the LCD monitor. The main modules are
accessed by tabs located at the bottom of the display. Click on these tabs to access the modules.
Print Job Control is the default module displayed when the software has finished loading after
the printer is switched on or reset.
The Print Job Control display is divided into functional and status areas. The functional areas
supports all operator input necessary to operate, maintain and service the printer. The status
areas are used to report printer status.
Onscreen Keyboard & Numeric Keypad
A mouse is used as the input device to navigate the menu-based interface. For operations that
require operator input, the mouse is used to select either numeric characters from a virtual
keypad or alphanumeric characters from a virtual keyboard. These virtual input screens are
displayed on the interface LCD monitor when data entry is required. In the example below, the
Network name of the printer is about to be changed.
Virtual Keyboard
Operator Interface Module Tabs
Interface Modules
Component
Print Job Control
(Print tab)
Maintenance
Printer Counters
(Counters Tab)
60 Chapter 3 - How to Navigate the User Interface
Function
Provides management of all aspects of working with print jobs. It also
controls some features of the printer.
Displays Maintenance tasks you must perform and indicates when to
do them. After you perform each task, the printer will record that and
then calculate when the task must be performed again. At that time you
will be reminded that the particular maintenance task is due.
Also provides access to Auto-Maintenance, Clean AMS, Replace UV
Bulb, and Move Carriage menus.
Provides information about the amount of ink consumed, the amount
of media printed and the number of print jobs started.
4