Figure 102. Removing the power interposer board
Next steps
Replace the power interposer
Installing the power interposer board
Prerequisites
1. Follow the safety guidelines listed in the
2. Follow the procedure listed in the
3.
Remove the air
shroud.
4.
Remove the
PSU.
5. Disconnect the cables that are connected to power interposer board (PIB) and observe the cable routing.
Steps
1. Align the slots on the power interposer board (PIB) with the hook on the system and lower it into place.
2. Using Phillips #2 screwdriver, tighten the screws to secure the PIB to the system.
board.
Safety
instructions.
Before working inside your
system.
Installing and removing system components
103