Table of Contents
Advertisement
Table 5. Left control panel with optional iDRAC Quick Sync 2 indicator (continued)
Item
Indicator, button, or
connector
3
iDRAC Quick Sync
2 wireless indicator
(optional)
NOTE:
For more information about the indicator codes, see the
Right control panel view
Figure 6. Right control panel view
Table 6. Right control panel
Ite
Indicator or button
m
1
Power button
2
USB 2.0-compliant port
3
iDRAC Direct port
(Micro-AB USB)
4
VGA port
12
System overview
Icon
Icon
Description
Indicates if the system is powered on or off. Press the power button to
manually power on or off the system.
NOTE:
compliant operating system.
The USB port is a 4-pin connector and 2.0-compliant. This port enables
you to connect USB devices to the system.
The iDRAC Direct port (Micro-AB USB) enables you to access
the iDRAC Direct Micro-AB features. For more information, see the
Integrated Dell Remote Access Controller User's Guide available at
https://www.dell.com/idracmanuals
NOTE:
(type AB) cable, which you can connect to your laptop or tablet. Cable
length should not exceed 3 feet (0.91 meters). Performance could be
affected by cable quality.
Enables you to connect a display device to the system.
Description
Indicates if the iDRAC Quick Sync 2 wireless option is
activated. The Quick Sync 2 feature allows management of the
system using mobile devices. This feature aggregates hardware/
firmware inventory and various system level diagnostic/error
information that can be used in troubleshooting the system. You
can access system inventory, Dell Lifecycle Controller logs or
system logs, system health status, and also configure iDRAC,
BIOS, and networking parameters. You can also launch the virtual
Keyboard, Video, and Mouse (KVM) viewer and virtual Kernel-
based Virtual Machine (KVM), on a supported mobile device.
For more information, see the Integrated Dell Remote Access
Controller User's Guide at www.dell.com/poweredgemanuals.
System diagnostics and indicator codes
Press the power button to gracefully shut down the ACPI-
You can configure iDRAC Direct by using a USB to micro USB
section.
.
Advertisement
Table of Contents
