Steps
1. Slide the BOSS cover on the BOSS S2 module. Using the Phillips #1 screwdriver, secure the BOSS cover on the BOSS S2
module with the M3 x 0.5 x 4.5 mm screw.
Figure 80. Installing the BOSS cover
2. Connect the BOSS power cable and BOSS signal cable to the BOSS S2 module.
Figure 81. Connecting the BOSS power cable and BOSS Signal cable to the BOSS S2 module
3. Slide the BOSS S2 module into the BOSS module bay until it is firmly seated.
4. Using the Phillips #1 screwdriver, secure the BOSS S2 module on the BOSS module bay with the two M3 x 0.5 x 4.5 mm
screws.
86
Installing and removing system components