Installing The Side Wall Bracket - Dell 2WMYN Installation And Service Manual

Figure 30. Removing the side wall bracket
Next steps
Replace the side wall bracket.

Installing the side wall bracket

There are two side wall brackets on either side of the system. The procedure to install is similar.
Prerequisites
1. Follow the safety guidelines listed in the
2. Follow the procedure listed in the
3. If installed, remove the air
4. Remove the cooling fan cage
NOTE: Ensure that you note the routing of the cables as you remove them from the system board. Route the cable
properly when you replace it to prevent the cable from being pinched or crimped.
Steps
1. Align the side wall bracket with the tabs on the chassis.
2. Press the side wall bracket with your thumbs until the bracket firmly clicks into place.
NOTE: Route the cables through the side wall bracket.
3. Close the side wall bracket cover with your thumbs until the cover firmly clicks into place.
Safety instructions.
Before working inside your
shroud.
assembly.
system.
Installing and removing system components 43