Table of Contents
Advertisement
Steps
1. Align and slide the right control panel assembly in the slot on the system.
2. Route the right control panel cable through the side wall of the system.
3. Align and slide the right control panel cable cover in the slot on the system.
NOTE:
Route the cable properly to prevent the cable from being pinched or crimped.
4. Connect the right control panel cable and VGA cable to the connectors on the system board.
5. Using the Phillips #1 screwdriver, tighten the screws that secures the right control panel and the cable cover to the system.
NOTE:
The numbers on the image do not depict the exact steps. The numbers are for representation of sequence.
Figure 112. Installing the right control panel
Next steps
1.
Install the cooling fan cage
2.
Install the drive backplane
3.
Install the air
shroud.
4. Follow the procedure listed in the
114
Installing and removing system components
assembly.
cover.
After working inside your
system.
Advertisement
Table of Contents
