Table of Contents
Advertisement
Figure 103. Installing the power interposer board
Next steps
1. Connect the cables to the PIB and route them properly.
2.
Install the
PSU.
3.
Install the air
shroud.
4. Follow the procedure listed in
Cooling fan cage board
Removing the cooling fan cage board
Prerequisites
1. Follow the safety guidelines listed in the
2. Follow the procedure listed in the
3. Remove the following components:
a.
Air shroud
b.
Cooling fan cage assembly
4. Disconnect cables from the fan board.
Steps
1. Using a Phillips #2 screwdriver. remove the screws that secures the fan board to the system.
2. Holding the edges lift the fan board out of the system.
104
Installing and removing system components
After working inside your
Safety
instructions.
Before working inside your
system.
system.
Advertisement
Table of Contents
