Modifying The Present Location Mark Location And Bearing - Sanyo NV-E7000 Installation And Operation Manual

MODIFYING THE PRESENT LOCATION MARK LOCATION AND BEARING

MODIFYING THE PRESENT
LOCATION MARK LOCATION AND
BEARING Adjust Current Location
Depending on the driving conditions and
the GPS satellite, the position/bearing of
the present location mark may differ
from the actual position/bearing of your
vehicle. By making sure there is nothing
obstructing the GPS satellite signal
reception and by driving at a constant
speed, the present location
position/bearing is automatically
corrected. However, you can correct
these yourself by following the steps
below.
Even if correcting the present location
while the unit is presently positioning
your vehicle after having connected
the GPS exterior antenna, the present
location will change to the position
determined by the GPS.
1
Use the joystick and align the
cursor to the present location
mark.
Cursor
Selecting the most detailed map
enables a more accurate position
correction!
2
Press the É button.
131
3
Select Adjust Current Location
from the drop-down
menu and press the Ä
button.
4
Verify the cursor position and
correct if necessary.
Position correction screen
Cursor
5
Press the Ä button.
The display changes for the
bearing correction screen.
Bearing correction screen
6
Correct the present location
mark with the Joystick (s)
and press the Ä
button.
Heading
7
Select Yes and press the
Ä button.
N
A
V
I
132