Disassembly And Reassembly - NEC VERSA 2600 Service Manual

4-4 Field Service Guidelines

DISASSEMBLY AND REASSEMBLY

This section contains step-by-step disassembly procedures for the system. Reassembly is
the reverse of disassembly. Each procedure is supported by a simplified disassembly illus-
tration to facilitate removal. The Illustrated Parts Breakdown and parts lists for the system
unit are shown later.
For complete disassembly of the system, follow the disassembly order listed in
Table 4-1. To reassemble, follow the table in reverse order.
Table 4-1 NEC Versa 2600 Series Disassembly Sequence
Sequence Part
1 Battery Pack
2 Hard Disk Drive
3 Keyboard
4 Heat Shield and CPU Board
5 LCD and Top Cover
6 VersaGlide Assembly
7 Sound Board
8 LED Status Board and IR Board
9 10X CD-ROM Reader and Heat Shield
10 Bridge Battery and FDD/HDD Connector Board
11 Diskette Drive
12 Power Board
13 Main Board
When disassembling the system unit, follow these general rules.
T
Turn off and disconnect all power and all options, including the AC adapter (if
connected) and battery packs (see the procedures that follow).
T
Do not disassemble the system into parts that are smaller than those specified in
the procedure.
T
Label all removed connectors. Note where the connector goes and in what posi-
tion it was installed.
See Page
4-5
4-6
4-7
4-9
4-11
4-13
4-14
4-15
4-15
4-16
4-17
4-18
4-18