Parallel Devices - NEC VERSA 2600 User Manual

Parallel Devices

To install a parallel device, such as a printer, you need a
cable with a male 25-pin connector for the system and, for
some parallel printers, a Centronics
connector.
NOTE
the appropriate printer driver through the Windows
Control Panel.
Connect a parallel device to your NEC Versa as follows.
1. Check that both the NEC Versa and parallel device
power are off.
2. Open the port cover on the back of the system and locate
the parallel port.
3. Align and connect the 25-pin parallel cable connector to
the parallel port on the system. Secure the cable with the
screws provided.
4. Align and connect the other end of the cable to the paral-
lel port on the device. Lock the connector clips.
4-30 Using Your NEC Versa
When you connect a printer, be sure to install
®
-compatible 36-pin