100-240V~, 600W 6.0-2.6A, 50-60Hz; Ultra2 Wide Scsi Path; Narrow Single Ended Scsi 10/100Base-T 10Base-T Console/Path; Path: 0/0/0/0 - HP A4500A - VMEbus Single Board Computer 744 Motherboard Hardware Manual

Initial Power-up
The following section describes the process of applying power to the server and booting the system to the
operating system Login prompt.
1. Apply AC Power to the system console.
2. Apply power to the server by pressing the rear panel On/Off switch IN.
100-240V~, 600W
6.0-2.6A, 50-60Hz
Ultra2 Wide SCSI
Path: 0/0/1/0
On/Off Switch
ccrr012
3. A series of self-test boot progress messages will scroll rapidly up the screen. Some messages may pause
for up to one minute while the test completes.
4. The initial power-up selftest process will complete in one to five minutes and the Boot Console Handler
(BCH) main menu will be displayed.
5. To start the boot process using the primary boot path, type BO PRI, at the BCH main menu prompt and
press .
ENTER
NOTE Booting a system to a operating system login prompt from BCH main menu can take 20
minutes or longer depending on your software and hardware configuration.
6. Once the system reaches the operating system login prompt, a display similar to the following will be
shown on the console screen:
Chapter
GSP Reset TOC
A
B
Narrow Single Ended SCSI 10/100BASE-T
Path: 0/0/2/0

Path: 0/0/0/0

10BASE-T Console/
LAN Console UPS Port
Initial Power-up
win win
Path: 0/2/0 Path: 0/4/0
urbo
urbo
Path: 0/6/2 Path: 0/6/0
117