HP A4500A - VMEbus Single Board Computer 744 Motherboard Hardware Manual page 157

Front Bezel Removal
The rp24xx server does not have to be turned off to remove the bezel.
WARNING Do not attempt to lift or carry the server by the bezel. The bezel is made of plastic
and is attached to the server chassis by two bezel retainers and four ball-posts. It
will only support the weight of the server chassis in an emergency.
Failure to heed this warning may result in personal injury and/or permanent
damage to the server.
Removing the bezel provides access to the following:
• HotPlug Disk Drive access door.
• Two knurled thumbscrews that secure the server cover.
To remove the bezel, grasp the bezel at the sides and pull straight out until it is free of the bezel retainers and
ball-posts on the server.
Pull the bezel straight out. Do not twist or wiggle from side-to-side any more than necessary to
CAUTION
keep from damaging the bezel sockets.
The following illustration shows a server and bezel with the bezel retainers and ball posts in an exploded
view.
The following picture shows one server with the front bezel attached and one server without.
Chapter
Front Bezel Removal
229