HP A4500A - VMEbus Single Board Computer 744 Motherboard Hardware Manual page 201

Insert the Server into the Rack
Insert the Server into the Rack
rp24xx servers are available in three configurations: rack-mounted, stacked, or stand-alone. Access to servers
mounted in an HP-supported rack is covered in this section.
To return the server into the rack, perform the following steps:
Step 1. Push and hold each rail clip in to unlock the rail from the fully extended position. Slowly push
server chassis completely into the rack.
Step 2. Replace the four T-25 screws on each side of the server that fasten it to the rack.
Step 3. Attach the front Bezel.
The following graphic shows the server extended and indicates the rail clip location.
ccrr014
297
Chapter