HP A4500A - VMEbus Single Board Computer 744 Motherboard Hardware Manual page 58

Racked Server Site Requirements
Cabinet
Product Description
Number
C2787A Field
Integrated
2.0m x 19"
Cabinet
Cabinet Minimum Service Access Requirements
Access
Location
*Rear 61 cm
Sides 30 cm
Front 101 cm
*Minimum distance required to fully open rear access door.
Non-HP Cabinet Installation Requirements
rp24xx servers can be installed in cabinets other than those manufactured by HP. Refer to the installation
instructions of the cabinet in which you wish to install the server.
WARNING Do not install a server in any cabinet without anchoring it to the cabinet with four
screws (two on each side) that attach to the front posts of the cabinet. Screws are
used as a safeguard against accidental ejection in case a cabinet tips forward. rp24xx
servers installed in all HP cabinets are secured with captive screws.
HP will NOT support servers that are not secured to the cabinet with screws.
Failure to heed this warning could result in serious personal injury or damage to the
server.
66
Max.
EIA
Servers
41 20
(24 in.)
(12 in.)(When extended)
(40 in.)
External Dimensions
(width x depth x height)
Centimeters
61 x 91.4 x 203.2
Inches
24 x 36 x 80
Chapter