HP A4500A - VMEbus Single Board Computer 744 Motherboard Hardware Manual page 89

Cabinet Installation
Installation of a factory-loaded cabinet consists of the following steps:
Step 1. Move the cabinet to the installation site.
Step 2. Lower the leveling feet. (This will prevent excessive wear on the casters, level the cabinet, and
provide stability.)
WARNING
Step 3. Connect the console and system peripherals to the server(s).
NOTE
Step 4. Connect the cabinet power cord to the appropriate wall outlet.
Step 5. Be sure all peripherals outside the cabinet are connected to wall outlets.
The cabinet/server system assembly is now ready for the power up process.
Chapter
Extend or install the cabinet stabilizers, located at the bottom of the front
of the cabinet, as an additional safeguard against the cabinet toppling
forward during installation.
Failure to observe this precaution could result in personal injury or death
and equipment damage.
Attaching cables while the rails are extended fully forward will ensure that sufficient
slack is available for later maintenance.
Cabinet Installation
97