HP A4500A - VMEbus Single Board Computer 744 Motherboard Hardware Manual page 81

Server Slide Rail Installation
The following information contains instructions for installing rp24xx servers in a cabinet.
CAUTION Both anti-tip feet must be properly affixed before installing equipment in a cabinet on a slide
assembly.
Tools needed: Torx Drivers, T15 and T20.
Slide Rail installation kit contents are as follows:
2 Slides, inner
2 Slides, outer
2 Slides mount, front
2 Slides mount, rear
2 Plastic bezel end caps
1 Cable Management device
1 see-through plastic bag containing:
2 bracket end caps
2 rack mounting ears
1 see-through plastic bag containing:
2 front RBI adapters
2 rear RBI adapters
2 cres fr flanges
4 M4 x 0.7 screws
10 10/32 x 0.5" screws
10 Sheet metal nuts
(Note: Contains non-E-series HP cabinet
hardware, also)
1 see-through plastic bag containing:
4 plastic snap rivets
4 sheet metal nuts
8 M5 screws
16 M4 screws
Chapter
Server Slide Rail Installation
89