Migrating Remote Console Switches To The On-Board Web Interface - Dell PowerEdge 180AS User Manual

Click the Upgrade Remote Console Switch Firmware button.
c
-or-
To discard those changes before the upgrade, click Yes.
The Firmware Upgrade dialog box appears. Select TFTP Server as the
d
source, and type the Trivial File Transfer Protocol (TFTP) server IP
address where the firmware is located as well as the filename and
directory location.
or
Click File System and browse to the location on your file system where
the FLASH file is located. Click Open.
3 Click the Upgrade button. The Upgrade button dims and a progress
message appears.
4 When the upgrade is complete, a message prompting you to confirm a
reboot appears. The new firmware will not be used until the switch
reboots. Click Yes to reboot the Remote Console Switch. The Upgrade
Firmware dialog box will display a progress message including a message
that the reboot is complete.
-or-
Click No to reboot at a later time. You will need to reboot in order to use
the new firmware.
NOTE:
When upgrading the Remote Console Switch firmware to a version that
supports the on-board web interface, it is recommend not to exit the AMP until the
reboot is complete. Otherwise, you must open the AMP after the reboot is complete
before the switch will be available in the Migration Wizard.
5 Click Close to exit the Upgrade Firmware window.
NOTICE:
Migrating Remote Console Switches to the On-
board Web Interface
After you have upgraded the firmware of a Remote Console Switch to a
version that supports the on-board web interface, the switch will be available
in the Migration Wizard. Complete the Migration Wizard to be able to
launch Viewer sessions and manage switches directly from the on-board web
interface.
173
Migrating Your Remote Console Switch
Do not power down the Remote Console Switch while it is upgrading.