HP D5970A - NetServer - LCII Installation And Configuration Manual page 11

Chapter 1
HP NetRAID-3Si External SCSI Cables
Channel External SCSI Cable
0
1
2
(1) External connections to both Channel 0 and Channel 2 at the same time require two
D6020A SCSI Cables. The connectors for Channels 0 and 2 are very close together, and
these cables have offset connectors that allow them to fit side-by-side.
If the necessary cables were not supplied with your system, see HP's Order
Assistant for ordering information. Order Assistant is available on the Internet at
http://www.hp.com/go/netserver.
HP NetRAID
The HP NetRAID adapter supports three channels. It has three connectors for
internal SCSI devices and two connectors for external SCSI devices for Channels
0 and 1. Optionally, you can connect an external port to Channel 2. (See
Chapter 4, "Planning," for instructions.)
Both internal and external connections support:
Fast/Wide SCSI (at data transfer rates of up to 20 MB/sec per channel)
Ultra/Wide SCSI (at data transfer rates of up to 40 MB/sec per channel)
The HP NetRAID adapter supports a maximum of six to eight devices per
channel depending on the HP system and enclosure used.
(1)
D6020A
D3637C or D6020A
(1)
D6020A
Introduction
3