Sample Alternate Switch Settings; Mass Storage Cables - HP D5970A - NetServer - LCII Installation And Configuration Manual

Appendix D

Sample Alternate Switch Settings

Mass Storage Cables

Some of the optional mass storage configurations require additional cables. This
table lists the cables used in configuring mass storage devices for this HP
NetServer. Only these HP cables and adapters are supported:
Cabling
Diagram
Label
C52 System backplane (or NetRAID
controller) SCSI connector to hot
swap backplane
C82 System backplane SCSI
connector to upper shelf SCSI
devices
D6 System backplane IDE connector
to IDE devices (CD-ROM or
other)
System backplane FDD
F6
connector to diskette drive
2
2
I C cable, system backplane to
I C
hot swap backplane
T
Location
3-connector, Wide (68-pin) SCSI
cable
2-connector, Wide 68-pin SCSI
cable with built-in terminator
3-connector IDE cable
2-connector flexible disk cable
2-connector I
SCSI terminator built into board
or cable
Cabling Diagrams
Description
2
C (3-pin) cable
151