Using Hp Netraid Assistant To Manage Servers; Before Starting Hp Netraid Assistant; Start Hp Netraid Assistant - HP D5970A - NetServer - LCII Installation And Configuration Manual

Chapter 9

Using HP NetRAID Assistant to Manage Servers

Before Starting HP NetRAID Assistant

The Registration Server must be running before any other servers are started.
If the Registration Server is a NetWare server, it must be running
reg_serv.nlm.
If the Registration Server is an NT server, it must be running the
NetRAID Registration Server icon (under the NetRAID program group).
To access an HP NetRAID Series adapter in a server from the network, the three
services listed below must be running. Start them in the order listed. You may set
them for automatic start, if desired.
1. NobleNet Portmapper: It should have been installed by the HP NetRAID
software and set for automatic start in Windows NT and Banyan VINES.
In NetWare, load rpcstart.nlm.
2. HP NetRAID Registration Server: Start it before the others by double-
clicking on its Windows icon or by loading NetWare module
reg_serv.nlm.
3. HP NetRAID Access Service: Start it by double-clicking on its Windows
icon or by loading NetWare module raidserv.nlm. It is set for
automatic start in Banyan VINES.
NOTE
To change the password for a server using Windows NT, run
setpass.exe under \netraid\dll\.
To change the password for a server using NetWare or Banyan
VINES, reinstall the HP NetRAID management software, as
described in this chapter, with the new password.

Start HP NetRAID Assistant

Run HP NetRAID Assistant from a client or server in which the HP NetRAID
Assistant utility was installed by clicking on the NetRAID Assistant icon in the
NetRAID program group (or group you specified).
If HP NetRAID Assistant is started on a standalone server, the main window is
displayed immediately.
Managing Servers Over the Network
109