HP D5970A - NetServer - LCII Installation Manual page 129

Chapter 13
Left Rear
Studs on slides
will mount through
this face of columns
Left Front
Stud on slide will
mount in fifth
hole from bottom
of server. Mark hole
for reference.
Figure 13-4. Mounting Hole Placement for the Slides
4. Again, hold the template alongside the inside face of the left-rear rack
column. Again, the template directs you to a single rack-column hole.
Mark it for reference.
5. Now attach a slide to the left-front and left-rear columns:
a. Hold the slide so that it is in side the left-front and left-rear rack
columns. See Figure 13-5.
b. Make sure the front end of the slide -- the end that extends when
pulled -- faces the front of the rack.
c. Insert the slide's two threaded studs into the marked holes on the sides
(outside faces) of the left-front and left-rear rack columns. See Figures
13-4 and 13-5.
Alternative Rack Mounting
Right Rear
Studs on slides
will mount through
this face of columns
Right Front
Bottom of
Server
121