HP D5970A - NetServer - LCII Installation Manual page 79

Chapter 7
10. Remove the processor from its sealed bag. Make sure that the retaining
latches on top of the processor are open (pointing straight up). Then
firmly push the processor into its slot in the processor cage. Make sure
that it seats firmly in its connector. See Figure 7-5.
NOTE You are not required to use the HP NetServer Navigator CD-
ROM to reconfigure your system after installing the new
processor board. The system detects the additional processors
automatically. However, we recommend that you use the HP
Navigator CD-ROM to ensure that you have the latest drivers
and information.
Figure 7-5. Installing a Processor
Installing Additional Processors
71