HP D5970A - NetServer - LCII Installation Manual page 137

Chapter 13
2. Swing the hinge open, to the left. See Figure 13-11.
3. Looking through the open side of the hinge, you see three raised holes for
screws. These align with holes on the server itself. Insert screws into these
three holes and hand-tighten them. See Figure 13-12.
1. Insert screws into
holes through open
side of hinge
Hinge in
open position
Figure 13-12. Fastening the Bezel Hinge to the Chassis
4. Swing the hinge closed. Use the access holes in the top of the hinge to
insert a driver and finish tightening the three screws. See Figure 13-12.
Alternative Rack Mounting
2. Swing hinge closed
(to the right)
3. To tighten screws,
insert driver through
access holes in top
of hinge.
Hinge in
closed position
129