Table 4.3 Self-Test Results Values - Fujitsu MAX3073NC - SCSI,80, Dell DC961,Hard Drive Scsi Logical Interface Specifications

Parameter Data Formats
When the self-test is initiated, the value specified in the SELF-TEST CODE field in the CDB is reported
to the SELF-TEST CODE field by a SEND DIAGNOSTICS command.
The values reported to the "Self-Test Result Value" field are defined below.
Value
0h The self-test completed without error.
1h The background self-test was aborted by the application client using a SEND
DIAGNOSTICS command with the SELF-TEST CODE field set to 100b (Abort
background self-test).
2h The self-test routine was aborted by an application client using a method other than a
SEND DIAGNOSTICS command with the SELF-TEST CODE field set to 100b (e.g.,
by the ABORT Task, RESET CONDITION, or reception of an interrupt command as
described in Section 4.2).
3h An unknown error occurred while the device server was executing the self-test and the
device server was unable to complete the self-test.
4h The self-test completed with a failure in a test segment, and the test segment that failed
is not known.
5h The first segment of the self-test failed.
6h The second segment of the self-test failed.
7h Another segment of the self-test failed (see the SELF-TEST SEGMENT NUMBER
field).
8h - Eh Reserved
Fh The self-test is in grogress.
The number of the segment that failed during the self-test is shown in the "Self-Test Segment Number"
field. When the self-test is completed without an error, 0 is shown in the field.
The accumulated power-on time (unit: hour) in the event of an error occurring in the drive is shown in the
"Time Stamp" field.
Address information of the data block where that error occurred is shown in the "Address of First
Failure" field.
The error information in the same format as that used by sense data is reported to the "Sense Key,"
"Additional Sense Code," and "Additional Sense Code Qualifier" fields.
4-68
Table 4.3 Self-test results values
Description
C141-C010