Fujitsu MAX3073NC - SCSI,80, Dell DC961,Hard Drive Scsi Logical Interface Specifications page 273

K* C* Q*
5 20 00 Invalid command operation code
21 00 Logical block address out of range
24 00 Invalid field in CDB
25 00 Logical unit not supported
26 00 Invalid field in parameter list
5 3D 00 Invalid bits in IDENTIFY message
90 00 Initiator's SCSI ID not identified
6 29 xx Power on, reset, or BUS DEVICE RESET occurred
6 2A 01 Mode parameters changed
6 2F 00 Commands cleared by another INIT
6 3F 01 Microcode has been changed
02 Changed operation definition
7 27 00 Write protected
B 03 xx Peripheral device write fault
11 xx Unrecovered read error
13 xx Sync byte not found for data field
14 xx Record not found
15 xx Mechanical positioning error
B 1B 00 Synchronous data transfer error offset
43 00 Message error
44 9D SPC detected Sync offset error interrupt.
45 80 Select/Reselect failure
47 00 SCSI parity error
48 00 INITIATOR DETECTED ERROR message received
49 00 Invalid message error
* K: Sense Key
Q:
Additional Sense Code Qualifier
C141-C010
Table 5.3 Sense data error classification (3 of 4)
Outline of Error
There is an error in the command specification
contents.
An error was detected in the SCSI protocol in the
command execution sequence.
The IDD was initialized by a Power on, RESET
condition or BUS DEVICE RESET message.
The MODE SELECT parameters were changed
by another INIT.
Commands were cleared by another INIT.
Access to a read protected or write protected.
An unrecoverable SCSI related error occurred in
the command execution sequence.
C: Additional Sense Code
L: Logging Necessary? (shown in Section 5.2.3)
5.2 INIT Error Recovery Methods (Recommended)
L*
None
None
None
None
None
None
None
Need
Need
Recovery Method
(See Table 5.4.)
2
3
14
21
25
27
15
12
6
5-17