Chapter 3 Dimensions - Fujitsu TeamPoS 3000 XL Installation & Maintenance Manual

TeamPoS 3000 XL and XL
Chapter 3 - DIMENSIONS
This section shows the dimensions of the TeamPoS 3000 XL and XL
rd
peripherals. For 3 party peripherals not shown, refer to the appropriate 3
manufacture documentation. Note: All dimensions are expressed as mm and inches.
The TeamPoS 3000 XL and XL
standard, and in two colors, black and white. Comparable black and white units are the
identical size.
The standard unit can be stacked where peripherals (printer, keyboard, operator display
and customer display) are stacked on top of the control unit. This requires brackets to be
installed on the control unit that restrain movement of the peripherals. The cash drawer,
if stacked, is located under the control unit. In this case, brackets are installed on top of
the cash drawer to restrain the controller.
3.1 Standard TeamPoS 3000 XL and XL
Configuration Dimensions
503
19 3/4" to end of printer
Note: Dimensions taken with monitor facing straight forward. The 12" LCD
overhangs the right edge of the controller. In this position the widest point is
21 7/16". The customer display is mounted on a stacked adjustable pole which
can extend up to 23 5/16". The printer overhangs the rear edge by 3/4 inch.
The longest dimension front to back is 19 3/4".
D900000145
2
2
control unit is available in two sizes, compact and
490
19"
foot-print
Issue 3
2
control units and
2
12" LCD Stacked
Customer Display
560
adjusts from 476 to 592
22 ¼"
18 ¾" to 23 5/16"
450
17 ¾"
540
21 7/16"
Dimensions
rd
party
3-1