Turning The Projector Off; Selecting The Image Source - Epson PowerLite Cinema 500 User Manual

Turning the Projector Off

To turn off the projector, press the
button on the projector twice). Let the projector cool while the Ppower light flashes (about
30 seconds). Once the light stops flashing and stays on, it's safe to unplug the projector.
Caution: Turn the projector off when not in use. Continuous 24-hour-a-day use may reduce its
overall life. Never unplug the projector without turning it off and letting it cool as described above, or
you could damage it and reduce lamp life.

Selecting the Image Source

The Source buttons let you switch between images from different pieces of equipment
connected to the projector (such as a DVD player, cable or satellite box, or video game
console).
If you don't see the image you want, press the
which your video source is connected. For example:
To select the image source connected to
the Video port . . .
Note: Do not press the Input A or B button repeatedly, or you will change the Input Signal setting.
If the screen colors don't look right, make sure the correct Input Signal is selected (see page 19).
If you're projecting in a darkened room, press the
control). This lights up the buttons on the remote control.
To temporarily turn off the image and darken the screen (without turning off the projector), press
the Blank button. Press the Blank button again to return to normal viewing.
22
Selecting the Image Source
button on the remote control (or press the
Off
button that corresponds to the port to
Source
. . . press the Video button
button (located near the bottom of the remote
Power