Adjusting The Color - Epson PowerLite Cinema 500 User Manual

Adjusting the Color

You can use the settings described below to fine-tune the color of the image.
1. Select
Picture Quality
1. Select Picture
Quality
2. Click here
2. Select the desired
3. Do one of the following:
■
To adjust the intensity of each signal color, click
button to its right. Use
shades, and
■
To adjust the hue and saturation for all six colors, click
Adjust
green, blue, cyan, magenta, yellow), then click
■
To adjust the gamma curve, click
Custom Gamma Adjustment section. The new settings are applied to the currently
projected image. To apply the same settings at a later time, select
Color Mode (see page 24).
Select the colors
you want to display
on the graph
48
Using Cinema Color Editor
, then click
to use as a starting point.
Color Mode
Offset
for the lightest shades.
Gain
button to its right. Move the slider bar for any color you wish to adjust (red,
Adjustment of image
RBG
to adjust darker shades,
Apply
and then click the
RGBCMY
.
3. Select a Color
Mode to use
as a base
4. Select an
adjustment
method, then
click Adjust
(see below)
and then click the
Adjust
for intermediate
Gamma
and then click the
RGBCMY
.
button in the
Adjust
Customized
Click a color
selection
button, then
drag color
points up or
down along
the curve
as the