Sharp FO-165 Operation Manual page 11

LOADINGTHE FAX PAPER
Your fax prints by a process called thermal printing. The print head applies heat to
special paper which is chemically treated to change colour when heated, and this
creates the printed text or image.
Follow the steps below to load the sample roll of fax paper provided.
1
c
Grasp the finger hold on the right side of
the paper compartment cover, and pull
---
""i
up to open it.
--- -"~
-------- +-~
!
~- Remove the packing paper from the pa-
per compatiment.
2~y
Unwrap the roll of fax paper and insert it
<4
w {
",,
,P>
10
in the compartment
/:
,," ----
,--
K
~'::
I
~ - //
\/
YES
\
ti
,,-,
,;
'.
,,.
Important: The roll must be placed so
that the leading edge of the paper
unrolls from the bottom the roll. (The
paper is only coated on one side for
printing. If the roll is placed upside
down. the paper will come out blank
after printing.)
3
-F
T
"".<~7
4' -.
Metal cutter guide .
*
~~
1 ~
my g "'
\, /!~ .-
'1
- ,, ',,,,* a, 'm
Arrow ?~t
Note: If you have difficulvpassing the leading edge of the paper through the
opening, try cutting off the corners of the paper with a pair of scissors.
FO-165: Pull the leading edge of the pa-
per out from the roll about 20 cm. then
pass it under the roller and through the
opening in the back of the fax.
. Important: While pulling the paper
straight out from the back, close the
cover.
FO-365: Pull the ieading edge of the pa-
per out from the roll about 20 cm, then
pass it under the metal cutter guide and
through the opening in the back of the fax.
s Important: While pulling the paper
straight out from the back (make sure it
Arrow is aligned be~een the 9reen arrows as
shown in the diagram), close the cover.
INSTALLATION 1-5