Pioneer RM-V2550 Manual page 149

3 Adjustment examples
[1] Setting the ID
1) Enter the adjustment mode by
2) The main menu will be displayed. Press the
3) Check that the ID display at the top left of the screen is [– –]. Press the
When an ID has already been provided, delete the ID as follows and perform from step 1).
a) Press the
ADJ IN
1
b) Press the
c) Press the 5
4) The ID input standby state will be set. Use the
ID.
5) If several units are used, return to step 1) and set the ID of the next unit.
[2] Entering the adjustment mode of certain units only.
1) Enter the adjustment mode.
2) Check that all the screens display the adjustment mode. Press the
SELECT] of the main menu.
3) Another menu will be displayed. Press the
4) Input the ID of the unit to be adjusted.
5) Only the unit corresponding to the ID input will display the main menu. All other units will be in the
standby state.
6) Perform the usual adjustments.
7) a) To continue adjusting the screen for which ID has been selected
Press the MAIN MENU
b) Ending the adjustment mode
ADJ OUT
Press the
c) Adjusting another unit
Repeat the mentioned operation 1) to 7).
(Note) Even if a certain unit has timed-out and is shifting to the normal mode, be sure to perform one of the
following steps a) or b) or c). If not, the unit for which ID SELECT has not been performed will remain in
the standby state.
Example) When the ID=13 screen in the right figure is selected and left for
more than 180 seconds without performing any operation:
Bottom left screen : Normal mode
Other screens
To exit from these states, perform the following.
a) To continue adjustment
Press the
ADJ IN
ments.
b) To end adjustments
Press the
ADJ OUT
state.
c) To turn OFF the power
Press the
POWER
key.
ADJ IN
key to set the adjustment mode. The main menu will be displayed.
key and select [1. ID SET/CLEAR/SELECT].
key after pressing the
key to return to the main menu.
key and return to the NORMAL OPERATION MODE. Note)
: Standby state of the remote control adjustment
mode.
key to set all screens into the remote control adjustment mode, and perform adjust-
key and exit from the remote control adjustment mode of screens in the standby
key to turn OFF the power of all screens (STANDBY state).
1
key to select [1. ID SET/CLEAR/SELECT].
0 key to clear the ID number.
0
to 9 and
1
2
key to select [2. ID SELECT].
ADJUSTMENTS
1
key to select [1. ID SET].
F
to keys to input the
A
key to select [1. ID SET/CLEAR/
ID=21
139