Table of Contents
Advertisement
ADJUSTMENTS
<Assigning IDs from the remote control unit>
[1] Use the
ADJ IN
[2] The main menu is displayed. Press the
[3] Check that the ID indicator at the top left of the screen reads "—", then press the
ID SET".
If ID numbers are already assigned, press the
When this is done, the ID clear verification display appears as shown in the diagram. Now press the
5
key to return to "
[4] The ID input standby mode is set. Use keys
numbers.
[5] To adjust multiple screen multi projection units, return to "[1] Enter adjustment mode", then assign the
ID number for the next multi projection unit.
NOTE) To return to the main menu display after assigning the IDs for all the screens, operate the
86
key to start up all the screens in the adjustment mode.
1
0. ID CLEAR
OK? PUSH 5 KEY
1
Enter adjustment mode", then assign the ID number.
key to select "1. ID SET/CLEAR/SELECT".
key to select "0. ID CLEAR" from the main menu.
0
9
0
to
and
1
key to select "1.
A
F
to
to input the ID
ADJ IN
key.
Advertisement
Table of Contents
