Table of Contents
Advertisement
MVP MANUAL
(3) To set the system back to 4-screen magnification [@ command]
Input:
@h
(h=8 or 9)
Explanation: • For setting the system back to 4-screen magnification after convergence adjustment, etc.
• Used also when the normal 4-screen magnification output cannot be obtained due to incorrect
operations, etc.
@8
................... (Sets 4-screen magnification of the OPTION input)
@9
................... (Sets the 4-screen magnification of the V IN input)
NOTE) An input board must be added in order to display the image of the OPTION input. (Option)
2. Adjusting the picture frame
(1) To perform fine adjustment of the picture frame [&G command]
Input:
&Gh
Explanation: • Performs fine adjustments of the picture frame of the screen specified by the parameter h value.
h : VOUT output No. (0 to 3)
The parameter h value is as shown in the following figure when viewed from the front.
• Picture frame fine adjustment command. If the picture frame moves considerable, first perform
coarse adjustments of the picture frame using the &P2 command and &Q2 command. (Refer to
page 164.)
When &Gh is executed, the following is shown on the computer display.
&G3
+F –F: The horizontal and vertical adjustment values are output at the +F and –F positions.
• Note: For details of the picture frame adjustment procedure, refer to "Picture Frame Adjustment Procedure".
• Note: To end the adjustment, be sure to input
If
is not input, commands input thereafter may not be executed.
• Note: If the power is cut in this state, the new screen start position data will not be saved. To save the data,
execute &W1
160
0
1
2
3
(Bottom right screen of 4-screen)
: Input the following commands after
0
: To reset the picture frame fine adjustment data
L
: To move the screen to the left
R
: To move the screen to the right
U
: To move the screen up
D
: To move the screen down
: Ends the adjustment mode
. (Refer to the &W command.)
.
.
Advertisement
Table of Contents
