Mode Switch - Pioneer RM-V2550 Manual

Signal name
FG ............................. Frame Ground
TxD ...................... Transmitted Data
RxD ............................ Received Data
RTS ........................ Request to Send
CTS ............................. Cleat to Send
DSR .......................... Data Set Ready
SG ............................. Signal Ground
7 Baud rate switch
Selects the baud rate for the RS-232C.
Baud rate switch (8-bit DIP switch)
Functions of bits
Switch No. Function
1 Parity
2 Parity polarity
3 Character bits
4 Stop bits
5
Baud rate setting
6
(Note)
7 Reserved
8 (Note) Reserved
(Note)
SW7 should always be set to OFF.
SW8 should always be set to ON.
Baud rates available with SW 5 and 6
SW5 SW6
ON ON
OFF ON
ON OFF
OFF OFF
: Factory preset values
ON OFF
Yes No
Even Odd
8 bits 7 bits
2 bits 1 bit
See table below.
Baud rate (bps)
19200
9600
4800
2400
GENERAL SPECIFICATIONS

8 MODE switch

Selects the video output mode.
MODE switch details
Output Mode Details
SW
Frequency Output
No.
mode mode
NTSC VBS,Y/C
0
RGB
1
2
PAL RGB
4
5
NTSC VBS,Y/C
8
9 RGB
A
PAL RGB
C
D
The factory preset is "8" for RMD-V3104U.
Frequency mode
NTSC ........................ Vertical refresh rate 59.94Hz
PAL ........................... Vertical refresh rate 50.00Hz
Output mode
VBS (Video signal), Y/C or RGB is able to selected.
Yet, VBS, Y/C output are useful is only NTSC Standard
mode.
Standard / Double scan
Standard (Interlace) ................................................
................. Horizontal frequency 15.625kHz(PAL),
.............. Horizontal frequency 15.734 kHz(NTSC)
Double scan (Non-interlace) ..................................
................ Horizontal frequency 31.250 kHz(PAL),
.............. Horizontal frequency 31.468 kHz(NTSC)
Output mode
It is the function that mitigates the trunk piece
phenomenon by multiple visions unique scanning line
structure. There is a difference in an effect by the
magnification ratio and it is more effective as smaller of
the magnification ratio. Yet, it does not work in vertical
magnification ratio X 1.
CAUTION:
The Frequency mode for each input board is as follows.
Variable scan board ................................. NTSC, PAL
PAL / NTSC input board .............................................
.................. NTSC (NTSC source), PAL (PAL source)
In the case that a MODE NO other than the above is
set up, a proper picture is not output.
Standard/ Middle cut
Double scan recovery
mode
Standard OFF
Double scan
Standard
OFF
Double scan
Standard ON
Double scan
Standard ON
Double scan
17