Pioneer RM-V2550 Manual page 71

Step 3:
Preparing the screens
¶ Take off those protective metal plates (fittings H and V) which will not form the outer edge of the
system (Fig. 3-4-27).
Example: in the case of screen 4 of a 4-screen system, take off the protective metal plates on the
top and left sides.
¶ Attach the hook fittings (left and right) (see P49 [1] for how to do this).
Screws: 4 cross-recessed self-tapping screws (nominal diameter 4, length 10, cone point) per
fitting (included as accessories)
Work for 9- and 12-screen systems only
¶ Push position-determining pins (diameter 4mm, length 15mm; included as accessories) into the places
shown in Fig. 3-4-28, 3-4-29a and 3-4-29b. The hole for the pin is on the right side of the screen frame
and is marked with a circular seal.
9-screen system: 4 places; 12-screen system: 6 places
Pin
Fittings H
(Fig. 3-4-27)
Circular seal
(Fig. 3-4-28)
INSTALLATION AND ASSEMBLY
Fittings V
Remove
Remove
Leave
Leave
61