NEC Express5800/320Ma Technical Reference Manual page 33

Table 3-1. ftSMC System Inventory Component Properties (Continued)
Property
IDPROM: ModelName
IDPROM: SerialNumber
Internet Call-in Poll Interval
Internet Corruption Re-send
Count
Internet HTTP Proxy Address
Internet HTTP Proxy
Password
Internet HTTP Proxy User
Name
Internet HTTP Server Address
Internet Tunnel Server
Address
IsPrimary
LastGoodDump
LED State: Yellow
LED State: Red
LED State: Green
LED State: White
Description
This type of PROM, located on boards manufactured by NEC
Solutions (America), contains board identification information.
This type of PROM, located on boards manufactured by NEC
Solutions (America), contains board identification information.
The interval, specified in seconds, that the SMM waits between
polling Hub machines to find out if call-in over the Internet is
needed. The default value is 300 seconds (5 minutes).
The number of re-send attempts ftServer Manager will make before
removing the alarm, when an Internet corruption error is received
while sending alarms by Internet only.
A list of the HTTP proxy server addresses (host:port) that ftServer
Manager uses to send alarm messages over the Internet in a
space-delimited string (for example, myproxy1:8080
myproxy2:8080). Set to empty if no proxy is required.
The password to access the proxy server.
The user name to access the proxy server.
The HTTP server address (host:port) that ftServer Manager uses to
send alarm messages over the Internet. The host name may be
either a domain name (for example, www.necsam.com) or an IP
address in ASCII dotted-decimal format (for example,
192.52.248.194). The port number is optional (by default, HTTP is
80 and HTTPS is 443).
Tunnel server address (<host>) that SMM uses for dial-in over the
Internet. The host name may be either an FQDN
(inettunel.ecacsupport.com) or a dotted-decimal IP
(134.111.1.21). This address should be equal to the CN field of the
Web server certificate (use inettunel.ecacsupport.com by
default).
Identifies the primary VTM.
For systems equipped with VTMs. Specifies the memory dump
number of the last known good dump.
Indicates the state of an LED in the system (On, Off, NotPresent, or
Cycle). See the operation and maintenance guide for your system
for a description of the meanings of the LEDs.
ftSMC Component Properties and Actions
ftSMC Component Properties
3-9