14. Press the NEXT button.
" Tone Detect" will be displayed.
15. Press the SELECT button.
" Tone Det: Enable" will be displayed
and
" Enable" will blink.
16. Press the SELECT button to alternate between
" Enable" and " Disable" to select the desired
mode.
17. Press the MEMORY
button.
The LCD will stop blinking.
16. Press the NEXT button.
" Security
Type" will be displayed.
19. Press the SELECT button.
" Trunk Security" will be displayed
and blink.
20. Repeat pressing the SELECT button until the
desired security mode (None Security, Trunk
Security or All Security)
is displayed.
21. Press the MEMORY
button.
The LCD will stop blinking.
22. Press the NEXT button.
" Remote Sec. Code" will be displayed.
23. Press the SELECT button.
" RMT-Code
: 70000" will be displayed
and
" 0000" will blink.
24. Dial the code number with 4 digits (0000
through 9999).
l
To erase an incorrect
entry, press the
CLEAR button.
25. Press the MEMORY
button.
The LCD will stop blinking.
26. Press the NEXT button.
" User Sec. Code" will be displayed.
27. Press the SELECT button.
" USR-Code
1 : 60000" will be displayed
and
" 0000" will blink.
29.
30.
31.
Dial the code number with 4 digits (0000
through 9999)..
0 To erase an incorrect
entry, press the
CLEAR button.
Press the MEMORY
button.
The LCD will stop blinking.
To return to the initial program mode, press the
END button.
Programming Table
See page 7-10
Conditions
0
The Direct Inward System Access (DISA) cards
are necessary
to program the Remote Security
Code and User Security Code.
26. Repeat pressing the SELECT button until the
desired user code (1, 2, 3 or 4) is displayed.