Panasonic EASA-PHONE KX-T123211D Installation Manual page 94

Programming
1. Dial (23).
12.
" RS232C Parameter" will be displayed.
2. Press the NEXT button.
" NL-Code
: CR +
LF" will be displayed and
" CR+ LF" will blink.
13.
14.
3. Press the SELECT button to alternate
between " CR + LF" and " CR" to select the
desired mode.
15.
4.
.
Press the MEMORY button.
The LCD will stop blinking.
5. Press the NEXT button.
" Baud Rate : 1200B" will be displayed and the
" 1200B" will blink.
16.
17.
6. Repeat pressing the SELECT button until the
desired baud rate is displayed.
7. Press the MEMORY button.
Programming Table
The LCD will stop blinking.
See page 7-7.
6. Press the NEXT button.
" Word Lengt : 7bit" will be displayed and the
" 7bit" will blink.
Conditions
9.
10.
11.
Press the SELECT button to alternate between
" 7bit" and " 8bit" to select the desired mode.
mode.
0
0
Press the MEMORY button.
The LCD will stop blinking.
Press the NEXT button.
" Parity : Mark" will be displayed and the
" Mark" will blink.
If any of the above disallowed combinations are
selected, Warning tone will be heard. Press
the NEXT button and then repeat the procedure
of programming.
Repeat pressing the SELECT button until the
desired parity code is displayed.
Press the M EMORY button.
The LCD will stop blinking.
Press the NEXT button.
" Stop Bit : 1 bit" will be displayed and the
" 1 bit" will blink.
Press the SELECT button to alternate
between" 1 bit" and " 2bits" to select the
desired mode.
Press the MEMORY button.
The LCD will stop blinking.
To return to the initial program mode,press
the END button.
To return to the previous mode, press the
PREV button instead of the NEXT button.
The following combinations are disallowed.
parity
I
word length
I
stop bit length
I
mark 1 8 2
space 8 1
space 8 2
3-34