NEC Express5800 Series User Manual page 173

appears, click [OK]. The Data Viewer will be reconstructed and the tree and the status will be
displayed correctly.
Data Viewer
The system configuration of the host may have been changed. Do you wish to reconstruct the
tree?
Floppy Disk Drive Name
After unplugging and plugging the PCI module of the primary side, the floppy disk drive name of
[I/O Device] on Data Viewer may be different from the name that is recognized by the OS.
(Example: drive name on Data Viewer: "A"
Check the floppy disk drive name on Explorer.
Floppy Disk Drive Information
If you add or delete floppy disk drive connected with USB while the system is running, the drive
information under the [I/O Device] in the data viewer will be updated at the next system startup.
Information of the keyboard/mouse connected with USB
When the keyboard or mouse is connected with USB, the keyboard or mouse information under the
[I/O Device] in the data viewer is listed as "Unknown."
Ethernet Adapters You Do Not Use
If an Ethernet adapter is not used (no cable connected), set it to "Disable" in [Network Connections]
from Control Panel. If an Ethernet adapter you are about to disable has dual LAN settings (AFT
function), remove the dual LAN settings before disable it.
Data viewer display when only one of the PCI modules (IO modules) is operating
When only one of the PCI modules (IO modules) is operating (simplex mode), the SCSI enclosure
or mirror disk status cannot be displayed normally.
To check if the duplex mode changed to simplex mode, check the event log, alert viewer log, or the
status color of PCI module of data viewer.
Display of Ethernet Board of ftServer Utility
ftServer Utility displays the information of Network Controller.
Express5800/320Fc-MR has four in-built Network Ports. Two trees of the Ethernet Board are
displayed since a module has two Network Controllers.
drive name recognized by the OS: "B")
Installing and Using Utilities 5-27