Refresh Of View Based On State Change Alert Setting - NEC Express5800 Series User Manual

Refresh of View based on State Change Alert Setting

NEC ESMPRO Manager window will be updated on a system state change basis. This function is
OFF by default. See the [Setting] below about how to turn it ON.
NEC ESMPRO Manager window, if enabled, is updated by one minute-interval polling. Therefore,
there is some time-lag for NEC ESMPRO Manager to recognize changes in NEC Agent. By using
this function, the time-lag can be reduced. However, it may consume a little bit more network band
width since each state change will be notified to NEC ESMPRO Manager as some kind of alert.
[Setting]
1.
Select [Program]  [NEC ESMPRO Manager] from the Start menu and click [Manager
Settings].
2.
Check [Enable the State Change Alert Setting].
3.
Click the [Agent Setting...] button.
4.
Check the name of servers sending the state change alert to the Manager when the Agent
recognizes changes in the state.
Click the [Execute] button for the setting change to take effect.
[Manager Settings] dialog box
[State Change Alert Setting] dialog box
Installing and Using Utilities 5-75