NEC Express5800 Series User Manual page 316

8-40 System Upgrade
062-03020-000 Fibre Channel Board
List of slots to install optional PCI boards

"List of option PCI boards and installable slots:" on page 8-32.
Driver installation procedure

TIPS:
To perform this procedure, you have to log on the system as an Administrator or a member of the
Administrators group.
1.
Mount a Fibre Channel board, and then start the system.
2.
Start Device Manager from [Start] - [Program] - [Administrative Tool] - [Computer
Management], and check if "Fibre Channel Controller" appears under the [Other devices] as
many as mounted.
3.
Set the "NEC EXPRESSBUILDER" CD-ROM into the DVD-ROM drive and run the following
command after starting Command Prompt..
DVD-ROM drive:\HAS\W2K3\HASSETUP\FC\FCINSTΔDVD-ROM
drive:\HAS\W2K3\HASSETUP\FC
("Δ" represents a space)
Install is completed when the message "Install Completed Successfully!" is displayed.
After it is completed, update the driver by running the following command.
CSCRIPTΔDVD-ROM drive:\HAS\W2K3\HASSETUP\FCUP\UPDATE.VBS
("Δ" represents a space)
After the update is completed, close Command Prompt and restart the system.
4.
After the system is rebooted, start Device Manager from [Start] - [Program] - [Administrative
Tool] - [Computer Management], and check that "Emulex LightPulse LP1150-F4, PCI Slot n,
Storport Miniport Driver" are displayed under the [SCSI and RAID Controllers] as many as