NEC Express5800/320Fd-LR User Manual page 66
Nec servers user's guide
Hide thumbs
Also See for Express5800/320Fd-LR:
- User manual (504 pages) ,
- User manual (484 pages) ,
- User manual (116 pages)
Table of Contents
Advertisement
4-6 Linux Setup
CPU/IO module 0
Status LED
CPU/IO module 1
Status LED
When the AC power is on (The power cords are plugged to the wall outlet)
(1)
Confirm the POWER LED of the CPU/IO module.
If the POWER LED is lit, shut down the OS and unplug the AC power cord
after the POWER LED turns off.
If the POWER LED is turned off, unplug the AC power cord.
(2)
Execute the operation to be taken when AC power supply is turned off.
When the AC power is off (The power cord is not plugged into the outlet)
Connect the power cords to NEC Express5800/ft series in the following order:
(1)
Connect the power cord to the AC inlet A connector.
(2)
Connect the power cord to the AC inlet B connector.
(3)
Make sure that the CPU/IO module status LED is turned off.
Preparation is now completed.
PCI Slot Status LED
Rear side of device
PCI Slot Status LED
DUMP (NMI) Switch
AC Inlet
Connector A
AC Inlet
Connector B
Advertisement
Table of Contents
